NETGEAR CG3300CMR User Manual page 67

ports. You can usually determine this information by contacting the publisher of the
application or user groups or newsgroups.

To set up port triggering:
Select Advanced > Advanced Setup > Port Forwarding/Port Triggering.
1.
Select the Port Triggering radio button to display the port triggering information.
2.
Clear the Disable Port Triggering check box if it is selected.
3.
Note: If the Disable Port Triggering check box is selected after you configure
port triggering, port triggering is disabled. However, any port triggering
configuration information you added to the gateway is retained even though it
is not used.
In the Port Triggering Time-out field, enter a value up to 9999 minutes.
4.
This value controls the inactivity timer for the designated inbound ports. The inbound ports
5.
close when the inactivity time expires. This step is required because the gateway cannot be
sure when the application has terminated.
Wireless Cable Gateway CG3300CMR
Advanced Settings
67