NETGEAR CG3300D Installation Manual

Euro-Docsis 3.0 Wireless Cable Modem Gateway CG3300D

Package Contents

• Gateway
• Power adapter
• Vertical stand (recommended)
• Ethernet cable
• Installation Guide (this guide)
Start Here
Estimated installation time: 15 to 30 minutes.
You will need a computer with DHCP enabled and an available Ethernet port.
Installation
Follow these quick steps to install your gateway.
1. For better wireless performance, insert the
gateway into the stand as shown.
2. Connect the gateway. Use the coaxial cable provided by your cable company to
connect the cable port (A) to your cable outlet.
A
3. Connect your computer to the cable modem gateway with an Ethernet cable (B).
B
4. Attach the power adapter cable to the gateway and plug it into an electrical outlet.
Make sure that the Power button on the rear panel is in the On position.
Power button
After the gateway is connected and power is applied, the gateway automatically
attempts to do the following:
• Scan and lock the downstream frequency, and then link back in upstream
direction.
• Obtain an IP address for the gateway itself. Then the gateway assigns an IP
address for the connected PC.
• Connect to the Internet.
5. Wait about two minutes for the LEDs to stop blinking. Then verify the following:
The Power LED is solid green.
The Downstream and Upstream LEDs are lit.
The Internet LED is solid green, indicating a link has been established to the
Internet.
The LAN LED is lit that corresponds to the local Ethernet port where you
connected your computer.
For more information, see the LED table on the other side of this document.