Dust - Pre-Coated Boards; Dirt And Psa Adhesive - Alcohol And Cloth - GBC Orca 1600 Operation And Maintenance Manual

Orca 1600 Operation and Maintenance Manual

8.3 Dust - Pre-coated boards

a) The main rollers must be below 110
< 1 1 0
CA L 32 00
b) Set the nip of the rollers to the thickness of the
adhesive coated boards.
c) Set the roller pressure to which ever roller you
are cleaning to 20 - 40 psi..
d) Align the adhesive coated board in front of the
area on the roller to be cleaned.
e) Using the footswitch, run the adhesive coated
boards through the rollers.
f) Perform steps d) and e) again.
g) Do this as many times as needed to clean the
laminator rolls.
© GBC Films Group February 2001
o o
F ( 43 C ).
< 1 1 0
CA L 32 00
8.4 Dirt and PSA adhesive -
Alcohol and cloth
a) Allow the laminator to cool slightly to no higher
o
than 110 F ( 43
< 1 1 0
CA L 32 00
C L E A N IN G H E A T E D R O L L E R S C A N
IG N IT E T H E FU M E S!
b) Set the machine direction to FWD when cleaning
the pull rollers. Set the machine direction to REV
when cleaning the main rollers.
FW D
R E V
( if cleaning
pull rollers )
c) Remove the front table and table idler to gain more
access to the main rollers or remove the rear table
to gain more access to the pull rollers.
Maintenance
o
C ).
< 1 1 0
CA L 32 00
C AU T IO N
FW D
O R
R E V
( if cleaning
m ain rollers )
Page 8 - 3