Calibrations - GBC Orca 1600 Operation And Maintenance Manual

Installation

4.11 Calibrations

The following calibrations should be performed
by a qualified GBC technician before the machine is to be
operated. These calibrations may not be performed by
the operator. Improper calibrations can result in poor
lamination output.
T hese calibrations require the lam inator
to be pow ered up w hile the cabinets
are opened.
a) The main roller nip is to be calibrated.
b) The pull roller nip is to be calibrated.
c) All three photo-eyes are to be calibrated.
d) The drive chains are to be checked and
tensioned if necessary.
e) Air rate on both set of rollers are to be checked.
f) Safety check and control panel operation checks
are to be performed.
Page 4 - 14
E L E C T R IC AL
S H O C K
Orca 1600 Operation and Maintenance Manual
© GBC Films Group February 2001