Installation; Pre-Installation Check List - GBC FALCON 60 C Instruction Manual

F 60 C Operation and Maintenance Manual

4.0 Installation

GBC Films Group is committed to a program of
ongoing product improvement. As a result, we are
providing these instructions so you can insure that your
new Falcon 60 C Laminator is properly and securely
unpacked, moved, and installed. Installation should be
performed by a qualified technician.
Before a Falcon 60 C Laminator can be installed,
there are a few requirements that must be met. Make
certain that each of the requirements listed in the following
pre-installation checklist are met before beginning
installation.
Failure to follow the pre-installation check
list can result in damage to the laminator.
4.1 Pre-installation
Are doorways and hallways wide enough for the
laminator to be moved to the installation site?
Is there ample room for the laminator?
A work area must be established that allows for
operation in both the front and rear of the
laminator and provides space for efficient material
flow. Figure 4.1.1 illustrates a typical machine
area layout.
© April 2001 General Binding Corporation
CAUTION
Is the environment appropriate for the laminator?
The laminator requires a clean, dust and vapor
free environment to operate properly.
Have you contacted a certified electrician to both
wire the laminator and ensure that adequate power
is being supplied, having the appropriate capacity,
over current protection and safety lockouts are
available?
The Falcon 60 C requires single phase, 220 to
240 vac, 50/ 60 Hz, 10 amp service. No other
type of connection is permitted.
T he Falcon 60 C L am inator is a large and
heavy piece of equipm ent. It is necessary to
em ploy L IC EN SE D R IG G E R S O N L Y to
m ove the lam inator. T he lam inator is not
designed to be tipped up or sidew ays in any
w ay. Such action disturbs the exact
alignm ent of the rolling parts of the m achine
and requires extensive realignm ent. Y ou can
be crushed or seriously injured.
For instructions on how to connect power,
proceed to 4.9 Connecting power in this section.
Installation
W A R N IN G
Page 4 - 1