Section 6.0 Applications; Temperature Chart - GBC Orca 1600 Operation And Maintenance Manual

Orca 1600 Operation and Maintenance Manual
6.0 Applications
The Orca 1600 can accommodate Poly-in or
Poly-out films. Poly-out means the adhesive is on the
outside of the roll.
The shiny side of clear film must contact the main
rollers with the dull sides ( adhesive side ) facing out. Use
caution when loading matte or delustered film since both
sides appear dull.
The top and bottom rolls of laminating film must
be of the same width and be present simultaneously. If
performing a single sided lamination process, a craft paper
carrier or a substrate of the same width must be used in
place of the bottom laminate.
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
The process control charts and web diagrams
illustrated in this section are reference points only.
Parameters will vary with regards to laminate
thickness, laminate widths, laminate types, print
types, ink or toner types, paper types, environment
conditions and operator experience.
© GBC Films Group February 2001
WARNING

6.1 Temperature chart

The temperature chart is only a starting point for
general types of laminates. For optimal output quality, you
may have to adjust up or down from the suggested
temperature.
IN F O R M AT IO N
For optim al tem perature settings of
various lam inates, contact your
supplier or sales representative.
H ot lam inates
m il T e m p e ra tu re
2 1 5 - 2 2 0
3 m il
( 1 0 2 - 1 0 4
2 2 0 - 2 2 5
5 m il
( 1 0 4 - 1 0 7
2 2 5 - 2 3 5
6 m il
( 1 0 7 - 1 1 3
2 3 5 - 2 4 5
1 0 m il
( 1 1 3 - 1 1 8
IN F O R M AT IO N
G eneral rule: Sm aller prints require m ore
speed or less tem perature. L arger prints
require less speed or m ore tem perature.
Applications
S p e e d
b o n d pa p e r, E -s ta t, in k je t
o
F
3 - 7 fp m
o
C )
o
F
3 - 5 fp m
o
C )
o
F
3 - 5 fp m
o
C )
o
F
3 - 5 fp m
o
C )
Page 6 - 1