Generalmusic WK3 World Keyboard Owner's Manual page 287

START TO SAMPLE
1. Press REC (F8) to start sampling.
The display shows "Ready to Sample" only if
you have set a Trigger value. If not, you go
directly to point 2.
2. Activate the source to sample.
Speak into the microphone, play the instru-
ment sound, start the tape or whatever sound
source you are sampling.
The display will show "Sampling!!!" for the
recording period (a few seconds).
If you fail to emit the sound during the "Sam-
pling!!!" phase, press REC again and repeat
the operation.
3. Play on the keyboard to listen to your sample.
Play a note that falls within the range of the
selected Split. If you play outside the range,
you will not hear the sample.
If you sampled with only SplitA (range A0-
C8), note C4 will be the sample reference
note.
If you are sampling with all splits active, each
split will have its own reference note C from
which the sample is mapped across the re-
spective split range.
4. Press the SAMPLE button.
Your Sample is memorised directly to the
SAMPLES bank, location 8.
The SAMPLES bank corresponds to battery
backed Sample-RAM which maintains data
intact after turning off. To safeguard your
sample against cancellation due to incorrect
operations, save your Sample to disk using
the Save Sample operation, explained in the
Disk chapter 6, User Guide.
1
REC/EDIT SMP:[HIGH FREQUENCY]
SplA Lev Mapp Name Trg Freq (EDIT)(REC)
REC/EDIT SMP:[READY TO SAMPLE]
Press [ESC] for exit
2
REC/EDIT SMP:[SAMPLING !!!]
3
4
SAMPLES
EMPTY EMPTY
EMPTY EMPTY
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
EMPTY SAMPLE
EMPTY EMPTY
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Rec/Edit 20•7
○ ○