Table of Contents
Advertisement
Appendix
Troubleshooting
Problem:
Smell of gas is present
Solution:
Check for loose connections in the gas line. Perform a
leak test following the procedure on page 9 .
Problem:
Burner does not ignite
Solution:
Use the following procedure with the fi gure below.
Check the position of the sparker tip. It should be point-
ing forward towards the front of the burner.
•
•
•
•
•
Note: Turn off the gas at the source while troubleshoot-
ing.
Power Burner
LTR50001100, Rev. B
Make sure there is a blue spark at the electrode tip
to the burner.
Make sure the igniter wire is connected fi rmly to the
valve ignition device and the electrode.
Make sure the valve orifi ce is free of any debris, dust
or grease.
Make sure the valve orifi ce is aligned inside the front
hole of the burner.
If there is no spark at all, replace the electrode or
igniter wire.
23
www.calflamebbq.com
Advertisement
Table of Contents
