Avoiding An Area - Mercedes-Benz COMAND Operating Instructions Manual

Avoiding an area

General information
COMAND enables you to avoid areas you do not wish to drive through.
If you activate or deactivate a route block while route guidance is active, COMAND will cal-
culate a new route. If you activate or deactivate a route block while route guidance is inactive,
COMAND will use the new setting for the next route guidance.
The calculated route may include an area to be avoided if:
your destination is located in such an area.
R
there is no alternative route of comparable length available
R
Highways within blocked areas are always taken into consideration in the route calculation.
Avoiding a new area
To switch to navigation mode: press the ß button.
X
To show the menu: slide 6 the controller.
X
To select Options Options: turn and press the controller.
X
Select Route Route Settings Settings.
X
Select Avoid Options Avoid Options.
X
Select Avoid Area Avoid Area.
X
Select Avoid New Area Avoid New
X
A menu appears.
Select Using Map Using Map
X
If you select Using Using Map
If you select Address Entry Address
address ( page 83). The map appears with the crosshair after the address is entered.
Y
i
Equipment with a touchpad: alternatively you can carry out this operation using the touch-
pad ( page 30).
Y
Area.
or Address Address Entry Entry.
Map, the map with crosshair appears.
Entry, the address entry menu appears where you can enter the
Map functions
Z
127