Storing Destinations; Reading Out Traffic Reports - Mercedes-Benz COMAND Operating Instructions Manual

To select Traffic Traffic: turn and press the con-
X
troller.
To select Traffic Traffic Information
X
turn and press the controller.
Select Incidents Incidents,Speed Speed & & Flow
X
Flow. Flow
The display is activated O or deactivated
ª.
Reading out traffic reports on the
route
Introduction
The read-aloud function is only available while
route guidance is active. It reads out traffic
reports affecting the current route.
You can select from the following text reader
properties:
Language ( page 52)
R
Y
Text reader speed (
R
You can start the text reader function man-
ually or set it to automatic.
Starting the text reader function man-
ually
To switch to navigation mode: press the
X
Ø button.
To show the menu: slide 6 the control-
X
ler.
To select Traffic Traffic: turn and press the con-
X
troller.
Select Read Out All Messages on Read Out All Messages on
X
Route. Route
COMAND reads out the reports in
sequence.
If there are no reports for the route, the
Read Read Out Out All All Messages Messages on on Route
item is gray and cannot be selected.
To cancel the read-aloud function: select
X
Cancel Read-Aloud Function Cancel Read-Aloud
COMAND reads out the current report and
then exits the read-aloud function.
Information On On Map Map:
Flow or Free Free
page 48)
Y
Route menu
Function.

Storing destinations

Automatic read-aloud function
To switch to navigation mode: press the
X
Ø button.
To show the menu: slide 6 the control-
X
ler.
To select Traffic: turn and press the con- Traffic
X
troller.
Select Read Traffic Announcements Read Traffic Announcements
X
Automatically. Automatically
Depending on the previous status, switch
the option on O or off ª.
Recalculating the route dynamically
The Dynamic Traffic Route Dynamic Traffic Route
takes into account all of the traffic reports it
receives for the current route when calculat-
ing the route ( page 80).
Y
If you have selected Dynamic Traffic Dynamic Traffic
Route Route as the route type, COMAND guides you
to your destination along the updated route.
Storing destinations
General notes
If a route to a destination has been calculated,
COMAND saves the destination to the last
destinations memory. If the memory is full,
COMAND overwrites the oldest destination.
When you save the current vehicle position or
a crosshair position, this position is stored in
the "Last destinations" memory.
You can save destinations permanently in the
address book and on an SD memory card. For
instance, this is possible immediately after
entering an address.
117
route type
Z