Safety Guidelines - Mercedes-Benz 2013 S-Class Operator's Manual

S-class
Hide thumbs Also See for 2013 S-Class:
Table of Contents

Advertisement

The SRS components are in operational
readiness if the 6 SRS warning lamp is not
lit while the engine is running.
G
WARNING
The SRS self-check has detected a
malfunction if the 6 SRS indicator lamp:
does not light up at all
R
does not go out after approximately four
R
seconds after the engine is started
comes on after the engine was started or
R
while driving.
For your safety, Mercedes-Benz strongly
recommends that you have the system
checked as soon as possible at an authorized
Mercedes-Benz Center. SRS may otherwise
fail to activate when it is needed in the event
of an accident, which could lead to serious or
fatal injuries. SRS might also be activated
unexpectedly and unnecessarily, which could
also result in injury.
In addition, work carried out improperly on
SRS may render SRS inoperative or cause
unintended air bag deployment. Work on the
SRS system should only be carried out by
qualified specialist personnel. Consult an
authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system
to accommodate a person with disabilities,
contact an authorized Mercedes-Benz Center
for details. USA only: for further information
contact our Customer Assistance center at
1-800-FOR-MERCedes (1-800-367-6372).
Safety guidelines for seat belts,
Emergency Tensioning Devices (ETDs)
and air bags
G
WARNING
Damaged seat belts or seat belts that have
R
been subjected to stress in an accident
must be replaced. Their anchoring points
must also be checked. Only use seat belts
Occupant safety
installed or supplied by an authorized
Mercedes-Benz Center.
Air bags and pyrotechnic Emergency
R
Tensioning Devices (ETDs) contain
perchlorate material, which may require
special handling and regard for the
environment. Check your national disposal
guidelines. California residents, see
www.dtsc.ca.gov/HazardousWaste/
Perchlorate/index.cfm.
Air bags and ETDs are designed to function
R
on a one-time-only basis. An air bag or ETD
that has deployed must be replaced. PRE-
®
SAFE
has electrically operated reversible
belt tensioners in addition to the
pyrotechnic ETDs.
Do not pass seat belts over sharp edges.
R
They could tear.
Do not make any modification that could
R
change the effectiveness of the seat belts.
Do not bleach or dye seat belts as this may
R
severely weaken them. In a crash they may
not be able to provide adequate protection.
No modifications of any kind may be made
R
to any components or wiring of the SRS.
Do not change or remove any component
R
or part of the SRS.
Do not install additional trim material, seat
R
covers, badges, etc. to the:
padded steering wheel boss
-
front-passenger air bag cover
-
outer side of front seat bolsters
-
side trim next to the rear seat backrest
-
roof lining trim
-
Do not install additional electrical/
R
electronic equipment on or near SRS
components and wiring.
Keep area between air bags and occupants
R
free of objects (e.g. packages, purses,
umbrellas, etc.).
Do not hang items such as coat hangers
R
from the coat hooks or handles over the
door. These items may be thrown around in
the vehicle and cause head and other
49
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents