Safety Guidelines - Mercedes-Benz R 350 BlueTEC 2012 Operator's Manual

The SRS components are in operational
readiness when the + SRS warning lamp
is not lit while the engine is running .
G
WARNING
The SRS self-check has detected a
malfunction if the + SRS warning lamp:
does not come on at all
R
fails to go out approximately 4 seconds
R
after the engine was started
comes on after the engine was started or
R
while driving
For your safety, Mercedes-Benz strongly
recommends that you have the system
checked as soon as possible at an authorized
Mercedes-Benz Center. Otherwise the SRS
may not be activated when it is needed in an
accident, which could result in serious or fatal
injury. The SRS might also deploy
unexpectedly and unnecessarily which could
also result in injury.
In addition, improper work on the SRS creates
a risk of rendering the SRS inoperative or
causing unintended air bag deployment. Work
on the SRS must therefore only be performed
by qualified technicians. Contact an
authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system
to accommodate a person with disabilities,
contact an authorized Mercedes-Benz Center
for details. USA only: Call our Customer
Assistance Center at 1-800-FOR-MERCedes
(1-800-367-6372) for details.
Safety guidelines for seat belts,
Emergency Tensioning Devices (ETDs)
and air bags
G
WARNING
Damaged seat belts or seat belts that have
R
been subjected to stress in an accident
must be replaced. Their anchoring points
must also be checked. Only use seat belts
installed or supplied by an authorized
Mercedes-Benz Center.
Air bags and pyrotechnic Emergency
R
Tensioning Devices (ETDs) contain
perchlorate material, which may require
special handling and regard for the
environment. Check your national disposal
guidelines. California residents, see
www.dtsc.ca.gov/HazardousWaste/
Perchlorate/index.cfm.
Air bags and ETDs are designed to function
R
on a one-time-only basis. An air bag or ETD
that has deployed must be replaced. PRE-
®
SAFE has electrically operated reversible
belt tensioners in addition to the
pyrotechnic ETDs.
Do not pass seat belts over sharp edges.
R
They could tear.
Do not make any modification that could
R
change the effectiveness of the seat belts.
Do not bleach or dye seat belts as this may
R
severely weaken them. In a crash they may
not be able to provide adequate protection.
No modifications of any kind may be made
R
to any components or wiring of the SRS.
Do not change or remove any component
R
or part of the SRS.
Do not install additional trim material, seat
R
covers, badges, etc. to the:
padded steering wheel boss
-
front-passenger air bag cover
-
outer side of front seat bolsters
-
outer side of the seat bolsters of the rear
-
bench seat backrest
roof lining trim
-
Do not install additional electrical/
R
electronic equipment on or near SRS
components and wiring.
Keep area between air bags and occupants
R
free of objects (e.g. packages, purses,
umbrellas, etc.).
Do not hang items such as coat hangers
R
from the coat hooks or handles over the
door. These items may be thrown around in
I n f o r ma t i o n P r o v i d e d b y :
Occupant safety
39
Z