Wet Road Surface - Mercedes-Benz 2013 S-Class Operator's Manual

Notes on regularly inspecting wheels
and tires
G
WARNING
Damaged tires can cause tire inflation
pressure loss. As a result, you could lose
control of your vehicle. There is a risk of
accident.
Check the tires regularly for signs of damage
and replace any damaged tires immediately.
Regularly check the wheels and tires of
R
your vehicle for damage (e.g. cuts,
punctures, tears, bulges on tires and
deformation or cracks or severe corrosion
on wheels) at least once a month, as well
as after driving off-road or on rough roads.
Damaged wheels can cause a loss of tire
pressure.
Regularly check the tire tread depth and
R
the condition of the tread across the whole
width of the tire ( page 499). If necessary,
Y
turn the front wheels to full lock in order to
inspect the inner side of the tire surface.
All wheels must have a valve cap to protect
R
the valve against dirt and moisture. Do not
mount anything onto the valve (such as tire
pressure monitoring systems) other than
the standard valve cap or other valve caps
approved by Mercedes-Benz for your
vehicle.
Regularly check the pressure of all the tires
R
including the emergency spare wheel or the
spare wheel, particularly prior to long trips,
and correct the pressure as necessary
( page 501).
Y
Tire tread
G WARNING
Insufficient tire tread will reduce tire traction.
The tire is no longer able to dissipate water.
This means that on wet road surfaces, the risk
of hydroplaning increases, in particular where
speed is not adapted to suit the driving
conditions. There is a risk of accident.
If the tire pressure is too high or too low, tires
may exhibit different levels of wear at
different locations on the tire tread. Thus, you
should regularly check the tread depth and
the condition of the tread across the entire
width of all tires.
Minimum tire tread depth for:
Summer tires: â in (3 mm)
R
M+S tires: ã in (4 mm)
R
For safety reasons, replace the tires before
the legally prescribed limit for the minimum
tire tread depth is reached.
Tread wear indicators (TWI) are required by
law. Six indicators are positioned on the tire
tread. They are visible once the tread depth
is approximately á in (1.6 mm). If this is the
case, the tire is so worn that it must be
replaced.
Bar marking : for tread wear is integrated
into the tire tread.
Notes on selecting, mounting and
replacing tires
Only mount tires and wheels of the same
R
type and make.
Only mount tires of the correct size onto
R
the wheels.
After mounting new tires, run them in at
R
moderate speeds for the first 60 miles
(100 km) as they only reach their full
performance after this distance.
Operation
499
Z