Destination Reached - Mercedes-Benz 2013 S-Class Operator's Manual

Navigation
174
Select Cancel Route Guidance
X
W to confirm.
Continuing route guidance
To activate navigation mode: press the
X
S function button once or twice.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
Select Continue Route Guidance
X
press W to confirm.
COMAND calculates the route.
Destination or area of destination
reached
When you reach your destination, COMAND
displays a checkered flag and route guidance
is automatically ended.
For certain points of interest (e.g. airports),
the

Destination Reached

as well as the checkered flag.
Navigation announcements
Repeating navigation announcements
G WARNING
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Looking at the icons or map display can
distract you from traffic conditions and
driving, and increase the risk of an accident.
i
Audible navigation announcements are
muted during a telephone call.
If you have missed an announcement, you can
call up the current announcement at any
time.
and press
X
X
Switching navigation announcements
on/off
X
in the navigation
and
X
X
i
display is shown
Reducing volume during a navigation
announcement
The volume of an active audio or video source
can be automatically reduced during a
navigation announcement.
X
X
Setting the volume manually
X
or
X
To show the menu: press W the COMAND
controller.
In the navigation menu bar, confirm
with W.
To switch off: during the announcement,
press the 8 button on the multifunction
steering wheel.
You will briefly see the message:
driving instructions have been
muted.
To switch on: press W the COMAND
controller.
In the + navigation menu bar, press W
to confirm.
COMAND automatically switches the
navigation announcements back on when:
you have a new route calculated.
R
you start the engine again after having
R
left the vehicle.
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Audio Fadeout and press W to
confirm.
The function is switched on O or off ª,
depending on the previous status.
Set the volume during a navigation
announcement.
In the map display when the menu is
shown, select + and adjust the volume.
RPT
The