Hard Disk Format - Konica Minolta bizhub 200 Service Manual

10. Tech. Rep. Mode
10.8.7

Hard Disk Format

Functions • To format the hard disk.
• When a hard disk drive is installed.
Use
• When the hard disk is initialized.
1. From the Tech. Rep. Mode screen, touch [Function] → [Hard Disk Format] in that
order.
2. Press the Start key to start the HDD formatting sequence.
Setting/
NOTE
Procedure
• NEVER turn OFF the power while the formatting sequence is in progress.
3. Turn OFF the Main Power Switch, wait for 10 sec. or more, and turn ON the Main
Power Switch again.
10.8.8 FD
Functions • To set the maximum and minimum sizes for manually fed paper.
Use • When the Manual Feed Unit is replaced.
<Maximum Size>
1. From the Tech. Rep. Mode screen, touch [Function] → [FD] in that order.
2. Load paper with a maximum size of 301 mm into the Manual Feed Tray.
3. In the Touch Panel, touch [Maximum Size], and then press the Start key to automati-
cally adjust the setting.
Setting/
Procedure
<Minimum Size>
1. From the Tech. Rep. Mode screen, touch [Function] → [FD] in that order.
2. Load paper with a minimum size of 89 mm into the Manual Feed Tray.
3. In the Touch Panel, touch [Minimum Size], and then press the Start key to automati-
cally adjust the setting.
10.8.9 FC
Functions • To check the Finisher operations.
Mode 1: Performs the move operation for the Stapling Unit.
Mode 2: Performs the move operation for the Aligning Plate.
Mode 3: Performs the ascent operation for the Elevator Tray.
Mode 4: Performs the descent operation for the Elevator Tray.
Mode 5
*1
Mode 6 *1
Mode 7: Performs the open/close operations for the Exit.
Use
Mode 8 *2
Mode 9 *2
Mode 10: Drives the transport section.
Mode 11: Performs the open/close operations for the Shutter.
Mode 12
Mode 13: Performs the single rotate operation for the Storage Paddle.
Mode 14: Performs the single rotate operation for the Exit Paddle.
1. From the Tech. Rep. Mode screen, touch [Function] → [FC] in that order.
Setting/
Procedure 2. Select an operation, and then press the Start key to begin the operation.
*1: appears only when the Punch Kit PU-5016 is installed.
*2: appears only when the Saddle Kit SD-502 is installed.
*3: appears only when the Mail Bin Kit MT-501 is installed.
166
: Performs the Punch drive operation.
: Performs the Punch drive operation. (2 holes)
: Performs the drive operation for the Creasing Unit.
: Performs the open/close operations for the Saddle Exit.
*3 : Drives the Mail Bin Solenoid.
Field Service Ver. 2.0 Apr. 2006