Installation - Kenwood CK 231 DF Instructions For Use Manual

9 - INSTALLATION

This cooker has class "2/1" overheating protection so that it can be installed next
to a cabinet.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 50 mm must be left between the side of the cooker and the furniture .
The walls and kitchen furniture surrounding the appliance must be made of non-flammable
material . The veneered synthetical material and the glue used must be resistant to a tem-
perature of 90°C in order to avoid ungluing or deformations . It is recommended that a 10
mm gap to each side is made if the adjacent kitchen furniture is made of a plastic laminate
wrap .
Curtains must not be fitted immediately behind appliance or within 500 mm of the sides.
It is essential that the cooker is positioned as stated below .
We do not recommend the
cooker is located on a plinth .
If this is unavoidable, it will
be necessary to provide
safety measures to prevent
the appliance falling off .
The cooker must be in-
stalled by a suitably qua-
lified technician and in
compliance with local sa-
fety standards.
LEVELLING
The cooker is equipped with 4 levelling feet
which must be fitted to the base of the coo-
ker in the following manner:
• Place the cooker on its back as shown
in the figure 9.2.
• Screw the 4 leveling feet to the cooker .
• Stand the cooker and levelling it by
screwing or unscrewing the feet with
a spanner .
28
Fig. 9.1
Fig. 9.2