Kenwood CK 231 DF Instructions For Use Manual page 22

• Inside of oven: The oven should
always be cleaned after use when it
has cooled down . The cavity should be
cleaned using a mild detergent solu-
tion and warm water . Suitable proprie-
tary chemical cleaners may be used
only on enamel after first consulting
the instructions supplied with the oven
cleaner and testing a small sample
on the oven cavity . Abrasive cleaning
agents or scouring pads/cloths should
not be used on the cavity surface .

NOTE: The manufacturers of this ap-
pliance will accept no responsibility for
damage caused by chemical or abra-
sive cleaning .

Let the oven cool down and pay
special attention not to touch the
hot heating elements inside the
oven cavity.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the cooker is cool unscrew and re-
place the bulb with another one resistant to
high temperatures (300°C), voltage 230V
or 220-240V, type E14 and same power
(check watt power as stamped in the bulb
itself) of the replaced bulb .
Note: Oven bulb replacement is not cove-
red by your guarantee .
22
BURNERS
They can be removed and washed with
soapy water only .
They will remain always perfect if cleaned
with products used for silverware .
After cleaning or wash, check that burner-
caps and burner-heads are dry before pla-
cing them in the respective housings .
Check that the electrode "S" (figs. 8.1, 8.3)
next to each burner is always clean to en-
sure trouble-free sparking .
Check that the probe "T" (figs. 8.1, 8.3)
next to each burner is always clean to en-
sure correct operation of the safety valves .
Both the probe and ignition plug must
be very carefully cleaned.
To avoid damage to the electric ignition
do not use it when the burners are not
in place.
CORRECT REPLACEMENT
THE AUXILIARY AND SEMI-RAPID
BURNERS
It is very important to check that the bur-
ner flame distributor "F" and the cap "C"
has been correctly positioned (see figs. 8.1
- 8 .2) - failure to do so can cause serious
problems .
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly po-
sitioned (see fig. 8.5); the burner rib must
be enter in their logement as shown by the
arrow (see fig. 8.3).
The burner correctly positioned must not
rotate (fig. 8.4).
Then position the cap "A" and the ring "B"
(figs. 8.4 - 8.5).
OF