Rear Panel - Polaris MS4000 Service And Owner's Manual

MODEL: POLARIS RANGER CAB KIT INSTALLATION INSTRUCTIONS
1. VEHICLE PREP.
1.1 Remove the roll bar from the vehicle so the vehicle appears as shown in fig-
ure 1.1.
1.2 Remove the seat back (the actual back portion of the seat) from the roll bar
tubing as shown in fig. 1.2. Save these eight (8) bolts for reuse in step 3.1.
1.3 Remove and save the six (6) button head, self-tapping screws (3 per side) that
are in the floorboard as shown in fig. 1.3 (left, driver's side shown).
2. SIDE FRAME (left side)
2.1 Open the hood of the vehicle.
2.2 Install the left side frame to the vehicle by tucking the middle front section in
behind the plastic hood as shown in fig. 2.2. Using three (3) of the button
head screws previously removed in step 1.3, attach the lower portion of the
side frame to the floorboard. Using two (2) 5/16" x 3/4" hex. head bolts, steel
washers, and locknuts, attach the front middle section of the side frame to the
matching mounting surface on the vehicle as shown in fig. 2.2.

3. REAR PANEL

3.1 (NOTE: If installing the optional hard rear window, install window clips be-
fore installing seat back to rear panel.) Attach the seat back to the rear panel
as shown in fig. 3.1 using the eight (8) bolts that were previously removed in
step 1.2. (NOTE: the relief in the middle edge of the seat should be down to-
wards the bulb rubber side of the rear panel.)
3.2 Attach the mounting brackets to the rear panel with one (1) 5/16" x 3/4" but-
ton head screw as shown in fig. 3.2. (NOTE: visually line up the outer edge
and the two (2) slots before tightening the bolt.)
original screws
2 of the 8 bolts
are shown here
Fig. 1.3
Reuse
hole
floorboard
locations
bolts
Fig. 3.1
Rear Panel
assembly
two (2) hex. head bolts
line up edges
one bolt here
62
Fig. 1.1 Roll bar removed
Fig. 1.2 Back seat section
Fig. 2.2 Side
frame (front
middle section)
Fig. 3.2
Attach
mounting
brackets
REV. J
PAGE 3 OF 7