Overheating / Diagnosis - Polaris MS4000 Service And Owner's Manual

CLUTCHING

Overheating / Diagnosis

During routine maintenance, or whenever PVT system overheating is evident, it's important to check the inlet and outlet ducting
for obstructions. Obstructions to air flow through the ducts will significantly increase PVT system operating temperatures. The
vehicle should be operated in Low when plowing or pulling heavy loads, or if extended low speed operation is anticipated.
Possible Causes
Loading the vehicle into a truck or tall
trailer when in high range.
Starting out going up a steep incline from
a stopped position.
Driving at low RPM or low ground speed
(at approximately 3-7 MPH).
Insufficient warm-up of Utility Task
Vehicles™ exposed to low ambient
temperatures.
Slow and easy clutch engagement.
Towing/Pushing at low RPM/low ground
speed.
Plowing snow, dirt, etc./utility use.
Stuck in mud or snow.
Climbing over large objects from a
stopped position.
Belt slippage from water or snow
ingestion into the PVT system.
Clutch malfunction.
Poor engine performance.
GENERAL RANGE OPERATION
GUIDELINES:
Operating in Low Gear
Low is the primary driving gear. Low should be used in ALL driving applications except for driving on hard packed level surfaces
with light loads. In this circumstance, High may be used.
IMPORTANT: Using High for heavy loads, hilly terrain, or in wet, muddy conditions will increase the chance of
drive belt burning.
1. Use Low as the primary driving gear
for all RANGERs.
2. Use High only on hard packed,
level surfaces with light loads.
6.4
CLUTCH DRIVE BELT & COVER RELATED ISSUES: DIAGNOSIS
Shift transmission to Low during loading of the vehicle to prevent belt burning.
When starting out on an incline, use Low, or dismount the vehicle after first
applying the park brake and perform the "K" turn.
Drive at higher speed or use Low. The use of Low is highly recommended
for cooler PVT operating temperatures and longer component life.
Warm engine at least 5 min., then with transmission in neutral, advance
throttle to approx. 1/8 throttle in short bursts, 5 to 7 times. The belt will
become more flexible and prevent belt burning.
Fast, effective use of the throttle for efficient engagement.
Use Low only.
Use Low only.
Shift the transmission to Low, carefully use fast, aggressive throttle
application to engage clutch. WARNING: Excessive throttle may cause loss
of control and vehicle overturn.
Shift the transmission to Low, carefully use fast, aggressive, brief throttle
application to engage clutch. WARNING: Excessive throttle may cause loss
of control and vehicle overturn.
Shift the transmission to neutral. Using the throttle, vary the engine rpm from
idle to full throttle. Repeat several times as required. During this procedure,
the throttle should not be held at the full position for more than 10 seconds.
Clutch seals should be inspected for damage if repeated leaking occurs.
For inspection of clutch components, please contact your Polaris dealer. Shift
transmission to Low during loading of the vehicle to prevent belt burning.
Fouled plugs, foreign material in gas tank, fuel lines, or carburetor. Contact
you dealer for further service information.
Low: Heavy pulling, basic operational speeds less than 7 MPH, riding
through rough terrain (swamps, mountains, ect.), low ground speeds.
High: High ground speeds, speeds above 7 MPH.
Solutions / What to do
RANGER 4X4 / 6X6
H
L
N
R