Denon AVR-2113 Owner's Manual page 29

Measurement (2nd – 8th)
• In this step, you will perform measurements at multiple positions
(two to eight positions) other than the main listening position.
• Just one position can be measured but measuring multiple positions
increases the accuracy of the correction of acoustic distortion within
the listening area.
10
Move the setup microphone to position 2, select
"Continue", and then press ENTER
The measurement of the second position starts. Measurements
can be made in up to eight positions.
Audyssey Setup
Place the microphone at ear level at the 2nd listening position,
then select "Continue"...
Continue
Calculation
Audyssey Setup
Place the microphone at ear level at the 3rd listening position,
then select "Continue"...
Continue
Calculation
Repeat Last Test
• To skip measuring the third and subsequent listening position, use
ui ENTER
to select "Calculation" and press
13.
• To measure the second position again, use
ENTER
Last Test" and press .
DVD
11
Repeat step 10, measuring positions 3 to 8.
When measurement
"Measurements finished." message is displayed.
.
to proceed to step
ui
to select "Repeat
of position 8 is completed,
Audyssey Setup
Measurements finished.
Calculation
Repeat Last Test
26
Set up speakers (Audyssey ® Setup)
Calculation
12
Select "Calculation" and then press
a
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Setup
Calibration completed! Now calculating...Please wait.
50%
• Analysis takes several minutes to complete. The more speakers
and measurement positions that there are, the more time it takes
to perform the analysis.
ENTER .
v See overleaf