Denon AVR-2113 Owner's Manual page 89

5
Use o p to select the
configuration of the connected
speakers, and then press
ENTER .
Surround Back Setting for 7.1-channel playback using surround
back speakers.
ZONE2 Setting to assign the unit's built-in power amplifier
for ZONE2 and output the audio in stereo.
Bi-AMP Setting to use the front speakers via the bi-amp
connection.
Front Height Setting for 7.1-channel playback using front height
speakers.
Front B Setting to use the second set of front speakers for
playback.
6
Press o or BACK to exit the "Amp Assign" setting.
DVD
7
Set up "Channel Select"
Use ui to select "Channel Select", and then press
ENTER
.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Start
Channel Select
Subwoofer Measure
8
Use ui to select a channel, and then press
Front Select for setting the front speakers to be used. In this
case, go to step 9.
• "Front" can be set when "Assign Mode" is set to
"Front B".
Subwoofer Select for no subwoofers to be used. In this case, go
to step 10.
Surround
Select the number of surround back speakers to be
Back
used. In this case, go to step 11.
• "Surround Back" can be set when "Assign Mode" is
set to "Surround Back".
86
9
Use o p to select a front speaker, and then press
ENTER
.
A Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
10
Use o p to set whether or not a subwoofer channel is
measured, and then press
Measure Set for measuring a subwoofer.
Skip Set for no measuring of a subwoofer.
11
o p
Use to set whether or not a surround back
channel is measured, and then press
Measure
Set for measuring two surround back speakers.
(2spkrs)
Measure
Set for measuring a surround back speaker.
(1spkr)
Skip
Set for no measuring of a surround back speaker.
12
o BACK
Press or .
Preparation
Proceed to page 25
NOTE
After performing Audyssey ® Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
ENTER .
Audyssey ® Setup again.
Set up speakers
ENTER .
ENTER .
step 5.