Yamaha XT660Z 2008 Service Manual page 48

Item
Union bolt tightening (front caliper)
Hose brake clamp upper and
front stay
Bleeder tightening (front)
Holder brake hose and fork
Rear wheel shaft and nut
Puller chain bolt and swingarm
Rear wheel and disc brake
Union bolt tightening (rear caliper)
Idrostop and rear master cylinder
Bleeder tightening (rear)
NOTE:
1. First, tighten the lower ring nut approximately 45 Nm (4.5 m·kg, 33 ft·lb) by using the torque wrench,
swing full stroke the steering two or three times, then loosen the lower ring nut completely.
2. Retighten the lower ring nut at a torque of 7 Nm (0.7 m·kg, 5.1 ft·lb).
Thread Q'ty
size
M10 2 30 Nm (3.0 m·kg, 22 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M7 2 14 Nm (1.4 m·kg, 10 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M16 1 105 Nm (10.5 m·kg, 75 ft·lb)
M8 2 16 Nm (1.6 m·kg, 11.5 ft·lb)
M6 6 14 Nm (1.4 m·kg, 10 ft·lb)
M10 1 30 Nm (3.0 m·kg, 22 ft·lb)
M10 1 24 Nm (2.4 m·kg, 17.5 ft·lb)
M10 1 14 Nm (1.4 m·kg, 10 ft·lb)
2-24
TIGHTENING TORQUES
Tightening torque Remarks