Settings On The Programming Mode - Panasonic KX-NCP500 User Manual

3.1.2 Settings on the Programming Mode

3.1.2 Settings on the Programming Mode
You can programme features using the programming mode.
–
Setting Features
–
Clearing Features
•
To exit at any time, lift the handset.
•
To enter the programming mode when using a PS, refer to "Operating Instructions" for PS.
Setting Features
The default settings are shown in bold letters. For later reference, place a check mark in the boxes below to
indicate your customised setting.
Notice
The default value may vary depending on country/area.
To enter the programming mode
PROGRAM
OR
PAUSE
Press PROGRAM
or PAUSE.
Item
Your extension information
Display Contrast Selection
Preferred display contrast level
from the 4 levels available
196 User Manual
programming
input
Follow
Press ENTER
or STORE.
programming
input.
Programming In-
put
0 0
*1
0 1
To programme
selection &
OR
parameter
AUTO DIAL
STORE
Follow Selection
& Parameter.
Selection & Parameter
PT: The display shows the PBX number, slot number
and port number. (Some IP-PTs may not display the
extension number.)
<example>
EXT1050:10308
PBX no.
PS: The display shows the PS number.
<example>
EXT3001:99001
1
2
3
4
To exit
PROGRAM
OR
OR
AUTO DIAL
PAUSE
STORE
Press PROGRAM
Press ENTER
or STORE. or PAUSE.
Port no.
Slot no.
PS no.
Light
Little Light
Little Dark
Dark