Table of Contents
Advertisement
Assembly
5.
Prepare mortar in a container.
6.
Apply mortar to the gaps left open between the
island assembly (front and back).
7.
Let it dry for 15 to 30 minutes and brush the area
where the mortar mix was applied.
8.
Prepare grout in a second container.
9.
Fill the tile seam with grout using a small spatula or
your finger.
10.
Clean the grout with a damp rag.
11.
Let the grout and mortar dry for at least three
hours.
Granite Kit Instructions
Granite kits come in the following colors. Each contains
various tinting colors as listed below:
Sapphire Brown
Black
White
Blue
Brown
New Venetian Gold
White
Yellow
Blue
Page 6
Giallo Veneziano
Red-Brown
Yellow
Black
White
Uba Tuba (Labrador)
Black
White
Green
1.
Pour a small amount of epoxy resin and a small
drop of each tint color on a piece of a cardboard.
NOTE: Refer to the granite tint color reference chart
2.
Apply a small amount of the first tint color to the
epoxy resin using a mixing stick and mix well.
3.
Apply a small amount of the second tint color to the
epoxy resin and mix well.
4.
Apply a small amount of the next tint colors, one at
a time to the epoxy resin and mix well.
5.
Compare color of mixed epoxy resin with the color
of the counter top.
6.
If the colors do not match, add small amounts of
tint color (one at a time) and mix until the resin
mixture matches the color of the granite top.
7.
Add a small amount of hardener to the matching
resin mixture and mix well.
8.
Quickly fill one portion of the seam line with the
epoxy mixture. Remove the excess epoxy material
from the seam line using a razor blade.
9.
Let the epoxy material cure for five minutes.
10.
Pour a small amount of epoxy and hardener
separately on a piece of cardboard.
11.
Mix the epoxy material well with the hardener.
12.
Quickly apply the epoxy mixture to the seam line.
Remove the excess epoxy material from the seam
line using a razor blade.
13.
Let the epoxy material cure for five minutes.
14.
Repeat the previous steps until all the seam line is
filled with epoxy mixture.
15.
Clean the surface of the seam line with acetone.
Griddle and Griddle Storage
Similar to installing a drawer, you need to have a cutout
on your barbecue island as shown below. Align the
enclosure as shown, opening facing out. Make sure the
enclosure is aligned horizontally. Tighten the mounting
screws on both side of the enclosure to lock the
enclosure in place. Slide the griddle into the enclosure
to test the installation.
2007 Barbecue Island Owner's Manual
LTR20071036, Rev. A
Advertisement
Table of Contents
