Granite Kit Instructions; Griddle And Griddle Storage - Cal Flame MC800 Owner's Manual

Apply mortar to the gaps left open between the
6.
island assembly (front and back).
Let it dry for 15 to 30 minutes and brush the area
7.
where the mortar mix was applied.
Prepare grout in a second container.
8.
Fill the tile seam with grout using a small spatula or
9.
your finger.
Clean the grout with a damp rag.
10.
11. Let the grout and mortar dry for at least three
hours.

Granite Kit Instructions

Granite kits come in the following colors. Each contains
various tinting colors as listed below:
Sapphire Brown
Black
White
Blue
Brown
New Venetian Gold
White
Yellow
Blue
2008 Barbecue Island Owner's Manual
LTR20081036, Rev. A
Giallo Veneziano
Red-Brown
Yellow
Black
White
Uba Tuba (Labrador)
Black
White
Green
Pour a small amount of epoxy resin and a small drop
1.
of each tint color on a piece of a cardboard.
NOTE: Refer to the granite tint color reference chart
Apply a small amount of the first tint color to the
2.
epoxy resin using a mixing stick and mix well.
Apply a small amount of the second tint color to the
3.
epoxy resin and mix well.
Apply a small amount of the next tint colors, one at
4.
a time to the epoxy resin and mix well.
5. Compare color of mixed epoxy resin with the color
of the counter top.
6. If the colors do not match, add small amounts of tint
color (one at a time) and mix until the resin mixture
matches the color of the granite top.
7. Add a small amount of hardener to the matching
resin mixture and mix well.
Quickly fill one portion of the seam line with the
8.
epoxy mixture. Remove the excess epoxy material
from the seam line using a razor blade.
Let the epoxy material cure for five minutes.
9.
Pour a small amount of epoxy and hardener
10.
separately on a piece of cardboard.
Mix the epoxy material well with the hardener.
11.
Quickly apply the epoxy mixture to the seam line.
12.
Remove the excess epoxy material from the seam
line using a razor blade.
Let the epoxy material cure for five minutes.
13.
Repeat the previous steps until all the seam line is
14.
filled with epoxy mixture.
15.
Clean the surface of the seam line with acetone.

Griddle and Griddle Storage

Similar to installing a drawer, you need to have a cutout
on your barbecue island as shown below. Align the
enclosure as shown, opening facing out. Make sure the
enclosure is aligned horizontally. Tighten the mounting
screws on both side of the enclosure to lock the enclosure
in place. Slide the griddle into the enclosure to test the
installation.
Assembly
Page 5