Placing Baby & Infant Carrier In Base - Britax Steelcraft Instructions For Use Manual

HOW TO USE
C. Ensure slack is removed from the lap straps by pulling the shoulder
harness straps through the buckle tongues, then pull the Harness
Adjustment Strap to take up the slack in the harness, adjusting to a
firm but comfortable fit. Make sure that the baby's arms and legs
are free and the crotch strap is between the legs. Check that the
slack in straps is minimal.
Do not use the restraint if straps do not tighten and contact your
local authorised service agent for repair.
Pull Harness Straps
through the buckle in
direction of arrows
Hook Adjuster Strap on to the loop
to prevent tripping over the strap.
IMPORTANT:
Do not place the Baby Carrier on a table or a work-top, where it could
fall off or be knocked on to the floor.
CAUTION: A LOOSE HARNESS IS DANGEROUS
The end of the harness is connected to the cover to avoid tripping on
the end. Ensure the Harness adjustment strap hook is attached when
carrying the carrier (see above).
28
Pull Harness Adjustment
Strap to remove slack.
PLACING BABY & INFANT CARRIER IN BASE
A. Position the Infant Carrier over
the top of the base. Make sure the
Harness Adjustment Strap is not
caught between Infant Carrier and
Base then lower the Infant Carrier
into position.
B. Push down on the Infant Carrier
until an audible click is heard. Pull
on the Infant Carrier to ensure it is
correctly locked into position.
IMPORTANT:
Lift again to check engagement.
C. The handle may be rotated into other positions if needed.
OK
HOW TO USE
CLICK
Upper Infant Carrier
strap ready to be fitted
to Infant Carrier.
29