Travel System-Use With Stroller; To Install Infant Carrier Into Stroller - Britax Steelcraft Instructions For Use Manual

TRAVEL SYSTEM-USE WITH STROLLER

This Infant Carrier is designed to be connected to compatible
Steelcraft strollers. The following pages provide a general instructions
about using the Infant Carrier with a stroller which may differ slightly
for some strollers. Preferably use the attachment instructions
provided with your stroller. Use the stroller in accordance with the
instructions supplied with the stroller.
DO NOT LEAVE THE CHILD IN THE INFANT CARRIER FOR EXTENDED
PERIODS.
THE INFANT CARRIER IS DESIGNED TO PROVIDE MOBILITY
OUTSIDE OF THE CAR BUT IT SHOULD NOT BE USED IN PLACE OF
AN APPROPRIATE COT.
THE INFANT CARRIER MUST ONLY BE USED WITH A STEELCRAFT
STROLLER WITH COMPATIBLE ATTACHMENTS. DO NOT USE WITH
ANY OTHER STROLLER.
IF IN DOUBT ABOUT THE METHOD OF INSTALLATION OR SUITABLE
COMPATIBLE STROLLERS, CONTACT BRITAX CHILDCARE
CUSTOMER SERVICE ON 1300 303 330.
42
TRAVEL SYSTEM-USE WITH STROLLER
TO INSTALL INFANT CARRIER
INTO STROLLER
IMPORTANT:
Only use Infant Carrier with compatible
Steelcraft Stroller.
A. Where applicable, remove the
stroller seat or bassinet from the
stroller frame (refer to stroller
instructions). With the Infant Carrier
handle in the carry position, engage
the Infant Carrier tongue mouldings
on each side directly over the
stroller frame mouldings.
B. Push down on the Infant Carrier
and make sure it is located into
the stroller frame mouldings. The
Carrier is not yet fixed to the stroller.
A.
B.
43