Securing Baby In Infant Carrier - Britax Steelcraft Instructions For Use Manual

HOW TO USE
A. Loosen Harness Straps by pressing
the Harness Adjuster while grasping
both the Shoulder Harness Straps
and pulling out the desired amount
of slack.
Press the Harness
Adjuster and pull Harness
Straps to loosen.
B. Move the two harness tongues to the
outer extents of the infant carrier.
Move the harness buckle towards the
Harness Adjuster.
C. Place baby into Infant Carrier lying on its
back so that the buckle is between the
baby's legs. Ensure that baby's arms and
legs are free. Make sure baby is dressed
to allow the Harness Buckle to be pulled
up between baby's legs e.g. a jump suit.
Never wrap the baby in a blanket before
placing in the Infant Carrier.
NOTE: Discontinue using the Padded Insert if the Pad cause over
heating, discomfort or you need more room for the child to grow.
26

SECURING BABY IN INFANT CARRIER

A. Place each arm through each shoulder
strap of the harness. Position the buckle of
the crotch strap as shown right.
B. Fit either harness tongue into the Harness
buckle followed by the other tongue until a
click is heard. If the second tongue does not
engage - press the red button and re-insert
the tongues. Check secure engagement by
pulling harness straps.
Tongue
CAUTION:
The end of the harness adjustment
strap is connected to the cover to
avoid tripping over the end. Ensure
the harness adjustment strap hook
is attached when carrying the carrier
(see page 28).
HOW TO USE
Buckle
Click
27