Ithaca 75 User Manual page 49

A = Journal Bucket Assembly
B = Nuts
Note: You do not need to separate the Printer from the Base Assembly, or
remove any of the boards to remove the Journal Bucket Assembly. If
you have already removed the Base Assembly and the boards, turn the
printer right-side up, but be careful not to damage the Carriage Cable.
1. If you have not already done so, unplug the following cables:
♦ Paper Low Switch (routing of the cable differs depending on the model)
♦ Journal Take-up Motor
2. Remove the three nuts (B) and washers (C) holding the Journal Bucket
Assembly (A) to the printer frame with a 9/32 inch nut driver.
The screws are riveted to the frame and cannot be taken out.
3. Pull the Journal Bucket Assembly (A) up until it clears the screws, then out
to remove it.
Be careful not to lose the Helper Springs (D) on the Forms Compensation
Arm.
Note: Reverse these procedures to reinstall the Journal Bucket Assembly.
Disassembly
C = Washers
D = Helper Springs
41