Ithaca 75 User Manual page 29

Note: This section describes removing the Transport-Auto Cutter Assembly
from the printer. See page 26 for removing the Auto Cutter Assembly
(without Transport).
1. Remove the Transport-Auto Cutter Assembly (A) from the Forms
Compensation Arm Assembly (C) by unscrewing the two screws (B) with a
#1 Phillips screwdriver.
The Ground Wire (D) is attached to the Forms Compensation Arm
Assembly (C) with one of the screws.
Do not try to unscrew the two 7/32 inch hex-head screws on the Platen.
They are for adjusting the Platen air gap.
2. Cut the tie wrap holding the cables to the frame.
3. Unplug the Transport Motor Cable and the Transport Sensor Cable from
the Interconnect Board.
Keep track of how the cables are routed.
Note: Reverse these procedures to reinstall the Transport-Auto Cutter
Assembly. Be sure to use new tie wraps to route the cables next to the
Base Assembly.
21
Disassembly