Ithaca 75 User Manual page 39

A = Base Assembly
B = Sems Screws
Note: Remove the Base Assembly from the rest of the printer before
disassembling the printer. After removing the Base Assembly, you can
then remove the AC Switch Assembly and the AC Power Transformer
from the Base Assembly.
1. Turn off the printer and unplug the Power Cord.
2. Disconnect the Communication Cable.
3. Remove all paper from the printer.
4. Remove the four Sems Screws and lock washers (B) from the top side of
the Base Assembly (A) with a #2 Phillips screwdriver as shown in the
illustration.
5. Lift the printer up from the right side an inch or two and disconnect the AC
Power Transformer Cable (C) from the Control Board.
6. Separate the printer from the Base Assembly.
7. Turn the printer upside-down to avoid damaging the boards.
Note: Reverse these procedures to reattach the Base Assembly to the printer.
Disassembly
C = AC Power Transformer Cable
31