Ithaca 75 User Manual page 35

A = Auto Cutter Assembly
B = Screws
Note: This section describes removing the Auto Cutter Assembly from the
printer. See page 20 for removing the Transport-Auto Cutter
Assembly).
1. Remove the two screws (B) holding the Auto Cutter Assembly (A) to the
Forms Compensation Arm Assembly (C) with a #1 Phillips screw driver.
The Ground Wire (D) is attached to the Forms Compensation Arm
Assembly with one of the screws.
Do not try to unscrew the two 7/32 inch hex-head screws on the platen.
They are for adjusting the Platen air gap.
2. Cut the tie wrap holding the Cutter Motor cables to the frame.
3. Unplug the Cutter Motor Cables from the Interconnect Board.
Keep track of how the cables are routed.
Note: Reverse these procedures to reinstall the Auto Cutter Assembly. Be
sure to use a new tie wrap to route the cables next to the frame.
Disassembly
C = Forms Compensation Arm
Assembly
D = Ground Wire
27