16
Series 70 Maintenance Manual
1. Turn off the printer.
2. Remove all paper from the printer.
3. Remove the Ribbon Cassette (A).
4. Set the Range Adjustment Lever (C) to position 1 (towards the rear of the
5. Slide the Carriage (B) all the way to the left.
6. Adjust the Left Adjusting Screw (D) behind the Platen (G) with a 7/32 inch
7. Slide the Carriage (B) all the way to the right.
8. Adjust the Right Adjusting Screw (E) behind the Platen (G) with a 7/32
9. Repeat steps five through eight until the gap is .012 all the way across the
10. Replace the Ribbon Cassette and paper.
11. Turn on the printer.
printer).
The Range Adjustment Lever is the blue lever on the Printhead (F).
nut driver until the gap between the Printhead (F) and the Platen is .012
inch.
inch nut driver until the gap between the Printhead (F) and the Platen is
.012 inch.
length of the Platen traveled by the Printhead.