Finishing Modes - Canon imageRUNNER C3489 Reference Manual

d Main Unit's Upper Right Cover, Main
Unit's Lower Right Cover
Open this cover when clearing a paper jam
inside the main unit. (See "Screens Indicating
the Locations of Paper Jams," on p. 8-4.)

Finishing Modes

The Finisher-Z1 is equipped with the following finishing modes.
NOTE
If the Collate or Group mode is set, the output tray moves downward as the stack of
paper that is output increases in quantity and thickness. Once the output tray has
reached its stacking limit, printing stops temporarily. Remove all of the prints from the
output tray, and printing resumes.
■ Collate Mode
The prints are automatically collated into sets arranged in page order. The collated print
sets can be shifted by pressing [Offset].
■ Group Mode
All prints of the same original page are grouped together. The grouped print sets can be
shifted by pressing [Offset].
■ Offset Mode
The print output is shifted alternately to the front and back of the tray, in a vertical (portrait)
orientation, or a horizontal (landscape) orientation depending on the orientation of your
originals. For example, if you place LTRR originals, the paper is output and shifted in the
horizontal direction. If you place LTR originals, the paper is output and shifted in the
vertical direction.
NOTE
If you press [Offset] when either the Collate or Group mode is set, each set of prints is
shifted approximately 1 1/4" (30 mm) before it is delivered to the output tray.
e Paper Output Unit
Pull out the paper output unit to remove jammed
paper. (See "Finisher-Z1 (Optional)," on p. 8-40.)
3-21
Finisher-Z1
3