Finishing Modes - Canon imageRUNNER C3489 Reference Manual

Finishing Modes

The Finisher-Y1 and Saddle Finisher-Y2 are equipped with the following finishing
modes.
CAUTION
•
Do not place anything other than output paper in the trays of the finisher, as
doing so may damage the trays.
•
Do not place anything under the trays of the finisher, as doing so may damage
the trays.
IMPORTANT
Finishing modes cannot be set if you are using 12" x 18" (305 mm x 457 mm) or
12 5/8" x 17 11/16" (320 mm x 450 mm) paper.
NOTE
If the Collate or Group mode is set, the output trays move downward as the stack of
paper that is output increases in quantity and thickness. Once an output tray has reached
its stacking limit, subsequent prints are automatically delivered to the next available tray.
If all of the available trays have reached their stacking limits, printing stops temporarily.
Remove all of the output paper from the trays. The trays move upward, and printing
resumes.
■ Collate Mode
The prints are automatically collated into sets arranged in page order. The collated print
sets can be shifted by pressing [Offset].
■ Group Mode
All prints of the same original page are grouped together. The grouped print sets can be
shifted by pressing [Offset].
Finisher-Y1, Saddle Finisher-Y2, and Puncher Unit-M1
3
3-27