Setting The Baud Rate Of The Serial Port Of The Supervisor (Password 303) - AERMEC MULTI CONTROL Booklet

146 R 0
147 R 0
148 R 0
149 R -200
150 R -200
151 R -200
152 R -200
153 R 0
154 0
155 0

• Setting the baud rate of the serial port of the supervisor (Password 303):

Baud rate
19200 bps
ESC
D
Baud rate
19200 bps
6 // Yes
1 // Yes
255 // Yes
700 / °C Yes
1
10
700 / °C Yes
1
10
700 / °C Yes
1
10
700 / °C Yes
1
10
1 // Yes
0xFFFF // Yes
1 // Yes
1
Unit status (0:OFF, 1:STAND_BY, 2:PUMP_ON,
No No 3:COMPRESSOR_ON, 4:DEFROSTING, 5: NOT
CONNECTED, 6: ALARM PRESENCE)
No No Unit season (0:cooling, 1:heating)
No No Alarm code
No No Mix water output temperature
No No Mix water input temperature
No No External air probe temperature
No No DHW temperature
No No DHW status (0: OFF, 1:ON)
No No Presence of alarms in system
No No Alarm summary flag
The second window of the SYSTEM SETUP allows the installer
to set the communication speed of the serial port used for
BMS systems; this window displays the following information:
- BMS serial line communication speed (
baud rate currently set for the serial port of the supervision
systems.
A
From this window it is possible to:
B
(1) Set the baud rate for the supervisor serial port:
C
pressing the key will allow you to enter the modifi cation
C
mode and the value will be highlighted; by pressing the
A B
keys or it will be possible to modify the value currently
displayed, while pressing the key
the values that can be set with this parameter are:
- 9600 bit/s.
- 19200 bit/s.
- 38400 bit/s.
(2) Pass on to the next window:
to go to the next window of this menu, press the key
(3) Go back to the previous window:
to go back to the previous window of this menu, press the
key A .
(4) Exit this window:
press the key D to return to the selection of the USER menus.
1 ): indicates the
C will confi rm this choice;
B
.
GB
4598010_00
49