Setting The Type Of Units Installed (Password 303) - AERMEC MULTI CONTROL Booklet

• Setting the type of units installed (Password 303):

Type of unit
CHILLER
ESC
F
Type of unit
CHILLER
N:1
A
B
C
E D
N:1
1
2
The fourth window of the UNIT SETUP allows the user to set
the type of unit installed in the system; this window displays
the following information:
- Index of the unit to which the type of unit refers (
indicates which unit (1, 2, 3 or 4) the data currently displayed
refers to.
- Type of unit ( 2 ): indicates which type of unit has been
installed (numbered in the system based on the index
From this window it is possible to:
(1) Select a unit for which to set the type: pressing the keys
or E decreases or increases the index indicating which unit the
work setting currently displayed refers to (
(2) Setting type: pressing the key
modifi cation mode and the value will be highlighted; by pressing
the keys A or B it will be possible to modify the parameter value,
while pressing the key C will confi rm this choice; the types of units
possible are:
- COOLING ONLY.
- HEATING ONLY.
- HEAT PUMP.
Obviously if the system only has COOLING ONLY units, all the
settings linked to heating and DHW production will be deactivated.
(3) Go back to the previous window:
to go back to the previous window of this menu, press the
key A .
(4) Exit this window:
press the key F to return to the selection of the USER menus.
1 ):
1 ).
D
1 ).
C will allow you to enter the
GB
4598010_00
35