Table of Contents
Advertisement
SERVICE INSTRUCTIONS
7.16
Replacing the ACS Remote
Pre-requisites:
• Phillips screwdriver
• To modify a drive programme you will need: Programming software or a Handheld
Programmer and the Installation Manual of the ACS Electronics, available from Invacare®.
NOTE
All ACS remotes are supplied with a standard drive programme. If the driving programme has
been customised, then you will have to perform this customisation again, after installing the new
electronic module.
WARNING!
Any changes to the drive program can affect the driving characteristics and the tipping
stability of the mobility aid!
• Changes to the drive program may only be carried out by trained Invacare® specialist
dealers!
• Invacare® can only give a warranty for safe mobility aid driving behaviour - especially tipping
stability - for unaltered standard drive programs!
• Switch off the remote.
• Pull the bus cable (1) out of the remote.
• Loosen the thumb screw (2).
• Pull the remote and the remote holder out of
the guiding device.
• Unscrew both remote holder screws (1) using
the crosstip screwdriver.
90
®
Invacare
- G50
Advertisement
Table of Contents
