Binatone TP-4050 Instruction Manual page 8

Never pour water out of the thermopot during boiling.
During the water boiling process or if hot water is in the thermopot,
do not touch any of the hot parts or the outer casing of the
appliance except for the heat-insulated handle.
To avoid hot steam causing burns, always tightly close the lid
before switching the appliance on. Avoid contact with hot steam.
ATTENTION! Never open the lid immediately before or
after boiling up.
Do not fill a hot thermopot with cold water or a cold thermopot
with hot water. ATTENTION! Avoid dramatic temperature
changes when filling the thermopot with water.
Only connect the appliance to a power supply that has protective
earthing. If your socket does not have this then contact a qualified
specialist. Do not modify the plug and do not use adapters. AT-
TENTION! Electrical shocks may happen when the ap-
pliance is connected to a power supply without protec-
tive grounding.
Clean calcium deposit (scale) from the thermopot heating ele-
ment frequently. Remember that the use of the thermopot with a
heavy scale deposit could damage the thermopot. ATTENTION!
To clean the appliance from scale, use products spe-
cially intended for this purpose.
Do not block the steam vents with any foreign objects. To prevent
burns, avoid direct contacts of the skin with a steam discharging
from the ports.
Take maximum care while opening the lid. Steam escaping from
the lid could cause burns.
To not move the appliance during water spills since splashes could
cause burns.
Do not remove the plug from socket while the appliance is oper-
ating. First, wait for the boiling process to complete.
To prevent uncontrolled spilling of water, do not incline the
thermopot, do not shake it and do not allow the appliance to fall
on the floor.
Do not use the lid to carry the thermopot; always use the special
handle for this purpose.
To avoid electrical current shocks, to not put the thermopot on
ice to cool the water in it.
Do not distort the power cable and do not place it near a
source of heat. Do not wind the power cable around the
appliance and do not put heavy objects on the cable.
Only use a dry cloth to remove dust from the power cable plug
or its contacts.
While disconnecting the appliance from the power grid, to do
not pull the power cable - grasp hold of the plug and pull!
Let the appliance completely cool down before cleaning or
storing.
Always disconnect the appliance from the power supply dur-
ing long-term storage, before filling the appliance with water
or emptying and before relocation of the appliance. While
transporting or storing the appliance make sure its empty of
water.
8