Advertisement
Available languages
Available languages
side where the control panel (8) is located. If water
penetrates inside the panel, this could result in failures
in the appliance operation.
4. Make sure that the water level is not above a mark "Full"on
the water level scale (2). Do not turn on the thermopot when
empty. Minimum required amount of water should not be lower
than the lowest mark on the water level scale.
Note: If the water level is lower than the small pipe on the
heating element, the protection system preventing
waterless operation activates and the appliance is
switched off.
5. Push the lid (3) to close it.
6. Connect the detachable power cable (14) and insert the plug
into a socket with a power supply with voltage that should
comply with the data indicated on the appliance.
Attention: Never connect the power cable if hands are wet.
7. When first connecting to a power supply, the indicator "Boil"
will light up and the thermopot will immediately start boiling.
Attention: Intensive evaporation may occur for several
minutes during boiling: it is a normal and necessary
to destroy chlorine contained in water .
8. IImmediately after boiling the thermopot will automatically switch
to "Keep Warm" mode. Indicator "Keep warm" will light up.
9. To pour water from the thermopot, switch the Manual safety
lock (E) to "Unlock" position. Place a cup under the water
supply port (10) and press the button "Dispense". Release
the button when the cup is full. Move the Manual safety lock
(E) to "Lock" position.
Attention: Always set Manual safety lock to "Lock"
position when not dispensing.
10.Water can also be dispensed by using the manual pump (6).
Unlock the pump (6) by moving the manual pump lock lever
(7) to "Open". Place a cup under the water supply port (6)
and push the pump button. Release the button when the cup
is filled up. Move the manual pump lock lever (7) to "Lock".
11.For water re-boiling, press the button "Boil".
12.Before re-using the appliance, empty the water out - as water
can change its color and odor, and yellow spots could appear
on the heating element.
Attention: To fully pour water out from the bulb, do not
use button "Dispense" or the manual pump. Pour out
water directly from the internal bulb.
5
Advertisement
