Installing Indoor Unit - Gree GWH09MA-K3NNA3F Service Manual

Installation Manual

7.3 Installing Indoor Unit

Installing Mounting Plate
1.Make the mounting plate completely level . As the water tray's oulet of the indoor unit is two-way type, the indoor unit during
installation should slightly slant to watert tray's outlet for smooth drainage of condensing water.
2.Fix the mounting plate on the wall with screws.(Where is pre-covered with plastic granula)
3.Be sure that the mounting plate has been fixed firmly enough to withstand the weight of an adult of 60kg; further more, the
weight should be evenly shared by each screw.
Wall
Space
to the
wall
1 5 0 m
above
Left
55mm
Ф55 or Ф65mm
Boring Piping Hole
1.Make the piping hole (
side.
2.Insert the piping-hole sleeve into the hole to prevent the connection piping
and wiring from being damaged when passing through the hole.
Installing Drain Hose
1.Connect the drain hose to the outlet pipe of the indoor unit.
Bind the joint with rubber belt.
2.Put the drain hose into insulating tube.
3.Wrap the insulating tube with wide rubber belt from the
joint of outlet pipe and insulating pipe so as to prevent
shift of insulating tube. The drain hose should be placed
at a downward slant for easy discharge of condensate.
Note: the insulating tube should be connected reliably with
the sleve outside the outlet pipe. The drain hose should be
downward slant, without distortion, bulge or fluctuation. Do
not put the water outlet in the water.
Mark on the middle of it
m
(Rear piping hole)
55 ) in the wall at a slight downward slant to the outdoor
Gradienter
(Rear piping hole)
Fig.5
Wall
Space
to the
wall
1 5 0 m m
above
Right
55mm
Ф55 or Ф65mm
Indoor
Wall pipe
outlet pipe of
indoor unit
outlet pipe of
drain hose
indoor unit
rubber belt
outlet pipe of
drain hose
indoor unit
rubber belt
insulating tube
rubber belt
outlet pipe of
indoor unit
insulating tube
connected
bulge
distortion
Flooded
Outdoor
Seal pad
55
31