Gree GWH09MA-K3NNA3F Service Manual page 22

Function and Control
mode, set temperature is not adjustable.
:
5 FAN
This button is used for setting fan speed in the sequence that goes from AUTO,
6
:
Press this button to set up &down swing angle, which circularly changes as below:
8
This remote controller is universal . If any command
indicates the guide louver swings as:
TIMER ON :
7
Press this button to initiate the auto-ON timer. To cancel the auto-timer program,simply press this button again.After press of this button,
disappears and "ON "blinks .00:00 is displayed for ON time setting. Within 5 seconds, press + or - button to adjust the time value.
Every press of either
minute and then
8
TIMER OFF:
Press this button to initiate the auto-off timer. To cancel the auto-timer program,simply press the button again.TIMER OFF setting is the
same as TIMER ON.
9 CLOCK :
Press CLOCK button,
seconds increases or decreases the time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During blinking after
setting , press CLOCK button again to confirm the setting,and then
10
X-FAN:
Pressing X-FAN button in COOL or DRY mode,the icon
order to dry the indoor unit even though you have turned off the unit.After energization, X-FAN OFF is defaulted. X-FAN is not available
in AUTO,FAN or HEAT mode.
11
TEMP:
Press this button to select displaying set temperature or ambient temperature. When the temperature display is changed from other state
to " ", the ambient temperature is changed. When other signal is received, the set temperature will be displayed. If the user
does not set temperature display state, it will display set temperature.
12 TURBO:
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in shortest time. In
COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air at super
high fan speed. (This function is not applicable for some models)
13
SLEEP:
Press this button to go into the SLEEP operation mode. Press it again to cancel. This function is available in COOL , HEAT (Only for
models with heating function) or DRY mode to maintain the most comfortable temperature for you.
Auto
Medium speed
Low speed
OFF
button changes the time setting by 1 minute. Holding down either button rapidly changes the time setting by 1
10 minutes. Within 5 seonds after setting, press TIMER ON button to confirm.
blinking. Within 5 seconds , pressing + or - button adjusts the present time.Holding down either button above 2
High speed
, or is sent out,the unit will carry out the command as
will be constantly displayed.
is displayed and the indoor fan will continue operation for 10 min utes in
,
,
, to then back to Auto.
19