Gree GWH09MA-K3NNA3F Service Manual page 25

3
Press this button to decrease set temperature.Holding it down above 2 seconds rapidly.decreases set temperature. In
AUTO mode, set temperature is not adjustable.
+
:
4
Press this button to increase set temperature.Holding it down above 2 seconds rapidlyincreases set temperature. In
AUTO mode, set temperature is not adjustable.
5
FAN :
This button is used for setting fan speed in the sequence that goes from AUTO,
6
:
● Press button to start or stop up & down swing function.The remote controller defaults to simple swing condition.
● Press + button and
blinking 2 seconds.
● In static swing condition, press
● If the unit is turned off during swing operation,the louver will stop at present position.
7 HEALTH SAVE:
● HEALTH function:there is no this function for this unit. If press this key, the main unit will click, but it also runs under
original status.
● Save energy function: After pressing SAVE button in cooling mode, the unit will turn to SAVE MODE. Meanwhile,remote
controller and indoor unit will all display "
mode. Meanwhile, remote controller will display "
:
8
● Press button to start or stop left & right swing function.The remote controller defaults to simple swing condition.
● Press + button and
blinking 2 seconds
In static swing condition, press
● If the unit is turned off during swing operation,the louver will stop at present position.
9
X-FAN:
Pressing X-FAN button in COOL or DRY mode,the icon "X-FAN" is displayed and the indoor fan will continue operation
for 10 minutes in order to dry the indoor unit even though youhave turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO,FAN or HEAT mode.
22
Auto
Medium speed
Low speed
button at the same time at unit OFF to switch betweensimple swing and static swing,
button, the swing angle of up & down louver changes as below:
".After pressing SAVE button in heating mode, the unit will turn to 8
button at the same time at unit OFF to switch betweensimple swing and static swing,
button, the swing angle of left & right louver changes as below:
High speed
" and indoor unit will display the setting temperature 8 .
Function and Control
, ,to then back to Auto.
heating