Gree GWH09MA-K3NNA3F Service Manual page 26

Function and Control
10 TEMP:
Pressing TEMP button,
temperatur) is displayed circularly .The unit defaults not to display the icon. During operation of TEMP button, the set
temperature is always displayed.
Note: Outdoor ambient temperature is only displayed for some models.
11 TIMER:
Press TIMER button at unit ON to set TIMER OFF, HOUR OFF blinking. Press TIMER button at unit OFF to set TIMER
ON, HOUR ON blinking. In this case, pressing + or -
changes time setting (time setting range 0.5-24hours). Press TIMER button again to confirm setting, HOUR O
stopping blink. If there is not any
will be canceled.
12
TURBO:
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in
shortest time. In COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the unit will
blow strong heating air at super high fan speed. (This function is not applicable for some models).
13
SLEEP :
Press this button to go into the SLEEP operation mode. Press it again to cancel. This function is available in COOL ,
HEAT (Only for models with heating function) or DRY mode to maintain the most comfortable temperature for you.
14
LIGHT:
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is
tunrned on,
3 3
4 and
About lock :
3
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
In this case, pressing any button,
3 2 2
and About switch between fahrenheit and cenrigrade
At unit OFF, press
Replacement of Batteries
1.Remove the battery cover plate from the rear of the remote controller. (As shown in the figure).
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Replace the battery cover plate.
Notes:
When replacing the batteries, do not use old or different batteries,
otherwise, it may cause malfunction.
If the wireless remote controller will not be used for a long time,
please remove batteries to prevent damage from leaking batteries.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the wireless remote controller does not operate normally, please
take the batteries out and replace them after 30 seconds. If still not
operating properly, replace the batteries.
(set temperature),
operation of button within 5 seconds during HOUR ON/OFF blinking,
is displayed. If the light is tunrned off
blinks three times.
" "
" - "
MODE and buttons simultaneously to switch between
(indoor ambient temperature) and
button changes time setting. Holding down either button rapidly
disappears.
and
(outdoor ambient
N/OFF
TIMER setting
is displayed.
.
Sketch map for
replacing batteries
23