Editing The Connected Ip Cameras And Configuring Customized Protocols - HIKVISION DS-8600 User Manual

User Manual of DS-9600/8600/7700/7600 Series NVR
3) Click Quick Add to add the camera.
3. To add other network devices:
1) On the left side of the interface, you can enter the IP address, protocol, management port, user name,
password and other information of the network device to be added.
2) Click Add to add the device.
3) (For the encoders with multiple channels only) check the checkbox of Channel No. in the pop-up
window, as shown in the following figure, and click OK to finish adding.
2.3.2 Editing the connected IP cameras and Configuring
Customized Protocols
After the adding of the IP cameras, the basic information of the camera lists in the page, you can configure the
basic setting of the IP cameras.
Steps:
1. Click the icon to edit the parameters, as shown in the following figure; you can edit the IP address,
protocol and other parameters.
Figure 2. 13 Selecting Multiple Channels
Figure 2. 14 Edit the Parameters
38