Remote Control Battery Installation; Remote Control - DVDO iScan Duo Owner's Manual

Remote Control Battery Installation

The remote control uses two AAA batteries (included), which should be replaced as needed.
To install the remote control batteries:
1. Locate the battery compartment on the back of the remote control.
2. Remove the cover from the back. To do this, push the cover in the direction indicated.
3. Remove the old batteries (if applicable).
4. Insert two new AAA batteries in the compartment as shown on the inside of the battery
compartment. Make sure the batteries are correctly inserted, observing the proper polarity.
5. After installation, replace the cover and recycle the old batteries (if applicable).

Remote Control

The supplied remote control is used to operate the iScan Duo. The table below describes the function
of the remote control buttons.
2
3
4
6
7
12
14
15
16
1
5
8
9
11
10
13
17
4