Table of Contents
Advertisement
Remote Control Battery Installation
The remote control for the iscan Vp20 requires two aaa batteries. These should be replaced as
needed. abT recommends alkaline batteries because they last longer without leaking.
To install the remote control batteries:
.
locate the battery compartment on the back of the remote control.
2.
Remove the cover from the back. To do this, press the tab attached to the cover and
pull the cover with the guide on the back of the remote control.
3.
Remove the old batteries (if applicable).
4.
insert two new aaa batteries in the compartment as shown on the inside of the battery
compartment. Make sure the batteries are correctly inserted, observing the proper
polarity.
5.
After installation, replace the cover and dispose of the old batteries (if applicable).
Menu Navigation
You can control the iScan VP20 as follows:
•
from the front panel controls
•
from the iscan Vp20 remote control
•
from a programmed universal remote control
•
using the serial connection on the back panel
The menu navigation controls on the remote control are duplicated on the front panel of the iscan Vp20.
To navigate the menu:
.
press the Menu button.
2.
use the directional buttons to highlight the parameter you want to change.
3.
press the Enter or Right button to select the parameter and the Up and Down buttons
to change the chosen parameter. press the Left button to stop adjusting a parameter
and to return to navigating the osd.
4.
press the Exit button to exit out of the menu/OSD.
Info Screen
press the Info button to display a window that shows information about the system including:
•
input status
•
Video source
•
signal Type
•
audio source
•
aspect ratio
•
output status
•
resolution
•
frame rate
•
line rate
•
aspect ratio
This screen can be helpful during troubleshooting.
8
Advertisement
Table of Contents
Need help?
Do you have a question about the iScan VP20 and is the answer not in the manual?
Questions and answers