Rename Inputs; Auto Wake Up; Auto Standby; Component Inputs - DVDO iScan Duo Owner's Manual

•

Rename Inputs

The Rename Inputs feature lets you customize your setup. The names you enter will appear
in the Select Input menu.
Select the input you want to rename with the remote control ENTER button.
Use the navigation
keyboard.
ENTER
Cancel
Finish
•

Auto Wake Up

Auto Wake Up provides more control over the conditions in which the iScan Duo will auto-
matically power on. The Auto Wake Up window gives you 3 options for defining the condi-
tions in which the iScan Duo will power itself on:
Off The iScan Duo will power on using the remote. Use this option if you want the iScan
Duo to remain powered down even if input signals become active.
Mode 1 The iScan Duo will power on automatically only if it powered down automatically.
If an input becomes inactive, the iScan Duo will automatically power itself off. If the
input becomes active again, the iScan Duo will automatically power on. If the iScan Duo
is powered down with the remote, then Auto Wake Up is turned off.
Mode 2 The iScan Duo will always automatically power on whenever an input signal is
present on any input.
•

Auto Standby

Auto Standby gives you control over the conditions in which the iScan will power itself down.
Off The iScan Duo never goes into standby mode. This is useful in cases where you may
not have an active video signal, but you may have an active audio signal passing through
the iScan Duo.
On The iScan Duo goes into standby mode after a brief interval when there is no active input.
•

Component Inputs

The Component Inputs menu gives you 3 options for controlling Automatic Gain Control on
Analog Component (YPbPr) Inputs:
Single Sync This is the default setting. Most component inputs will have sync only on the
Y signal.
Triple Sync A few devices will add sync to all three component input signals (Y, Pb, Pr).
If you know your device does this, choose this mode.
AGC Disable In some cases, Automatic Gain Control (AGC) will cause brightness
levels to be incorrect due to distortions in the analog input signals. Disabling AGC may
correct this problem.
In general, you should use Single Sync. If your picture does not look correct, experiment
with the other settings.
21
t p q u
, , , buttons to move the highlighted character around on the
puts the selected character in the edit bar.
exits the window with no changes.
exits the window and applies the new name.