Front Panel - Steinberg UR28M Operation Manual

Front Panel

HI-Z switch
Turns on ( ) and off ( ) the HI-Z of the MIC/
LINE/HI-Z.
Turn this switch on when connecting high
impedance instruments, such as an electric
guitar or electric bass, directly to the MIC/LINE/
HI-Z.
When you turn this switch on, use an unbalanced
phone cable for connection between the
instruments and the MIC/LINE/HI-Z. If you use a
balanced cable or an XLR cable, this device will
not work correctly.
CAUTION
• Do not connect or disconnect a device while turning
on the HI-Z switch. Doing so can damage the
connected device and/or the unit itself.
• To protect your speaker system, leave the monitor
speakers turned off when turning the HI-Z switch on/
off. It's also a good idea to turn all output volume
controls down to their minimum. Neglect of these
precautions may result in large noise bursts that may
damage your equipment, your ears, or both.
Panel Controls and Terminals (Details)
PAD switch
Turns on ( ) and off ( ) the PAD of the MIC/
LINE/HI-Z.
When you turn this switch on, the input signal
level of the MIC/LINE/HI-Z will be attenuated by
26 dB. Turn this switch on when connecting high
output equipment, such as a synthesizer, to the
MIC/LINE/HI-Z.
+48V button
Turns on (lit) and off (dark) the phantom power of
the MIC/LINE/HI-Z 1 and 2 (XLR type).
When you turn this button on, phantom power will
be supplied to the MIC/LINE/HI-Z 1 and 2. Turn
this button on when connecting phantom
powered devices, such as a condenser
microphone, to the MIC/LINE/HI-Z 1/2.
CAUTION
• Make sure that phantom power is turned OFF unless
it is needed.
Operation Manual
UR28M
7