Dedicated Windows For Cubase Series - Steinberg UR28M Operation Manual

SLIDER MOUSE CONTROL
Selects the method of operating the sliders and
faders on the dspMixFx UR28M.
Option Description
Jump Click any point on the slider and
fader to increase and decrease the
parameter. If you click any point on
the slider and fader, the parameter
will jump there instantly.
Touch Drag the handle of the slider and
fader to increase and decrease the
parameter. Even if you click any
point on the slider and fader, the
parameter will not jump there.
LOOPBACK
Turns the Loopback function on (lit) and off
(dark). When the Loopback function is set to ON,
the audio signals output from MIX 1 in the DSP
mixer (dspMix FX) in the device are returned to
the computer for actual broadcasting. Refer to
the section "Signal Flow" (page 35). When using
multi-track recording in audio recording software,
set the Loopback function to OFF.
Information Window
This window indicates information about the
dspMixFx UR28M and the device.
Panel Controls for the Software Programs
Version Information
Indicates the version of the firmware and
software. The letters "x.x.x" and "x.xx" indicate
the version number.
Check for update
Checks whether or not you have the latest
software and firmware version, via the Internet. If
a new version is found, follow the on-screen
instructions for updating.
Dedicated Windows for
Cubase Series
These are the windows for configuring the device
settings from Cubase series. The Dedicated
Windows for Cubase series allow you to configure
the parameters which are configured by the
dspMixFx UR28M. from Cubase series. Two types of
windows are available: Input Settings and Hardware
Setup.
Input Settings Window
This is the window for configuring the input settings
of the device. The signal flow is from top to bottom.
The settings on this window are saved to the
Cubase project file, except for the +48V indicator.
Hardware Setup Window
This is the window for configuring the general
settings of the device. Click the upper tabs to select
the window. Only the settings on the Reverb Routing
window are saved to the Cubase project file.
Screenshot
Input Settings Window
Operation Manual
UR28M
17